iPhoneX Motorcycle Bracket

prusaprinters

<p>Slide in bracket to hold the iPhoneX that I use on my motorcycle. Requires a mounting device like the Wunderlich MultiPod or RAM mount, 2 screws and nuts. I am new to 3D printing so if you have improvement suggestions or comments let me know. I might also be willing to modify this design to different needs.</p> <h3>Print instructions</h3><p>Slic3r 1.41.3. Settings</p> <p>0.10mm Detail<br/> PETG<br/> 40% Fill Density (seems to be plenty strong)<br/> Supports YES everywhere<br/> Brim YES (but probably could do without)</p> <p>Support Changes to Defaults:<br/> Overhand Threshold: 70% (Maybe adjust higher to improve cleanup?)<br/> Contact Z: 2mm<br/> Pattern: Honeycomb<br/> Spacing: 3mm<br/> Interface Layers: 1 (I read somewhere that this would be easier to remove than 2 layers, but it was still difficult to remove)<br/> Interface patterns spacing: 0.3mm<br/> Don’t support bridges: Turn This OFF! (i.e. NO checkmark. If you leave this on the back side will be a stringy mess)</p> <p>The cleanup takes some time and a very sharp knife to remove supports that are inside the bracket. Takes about 9 hours to print.</p>