Ipod Classic Bluetooth Case

thingiverse

!!!!ATTENTION!!! If you've downloaded the model before 7:00 PM 2/3/2020, I'm sorry to say I uploaded the wrong file!! That was V2! You need V6! make sure you check your file type! I've changed the file but it might be a little while before it takes effect! I apologize immensely I didn't notice until the model fully rendered on thingiverse!!!! This is a case for a gen 7 iPod classic that allows for the use of a TaoTronics Bluetooth module and a CESS 90 degree head audio jack. You will need a TaoTronics Bluetooth transmitter and receiver: https://www.amazon.com/TaoTronics-Bluetooth-Transmitter-Receiver-Simultaneously/dp/B01EHSX28M (MAKE SURE IT HAS THE REMOVABLE CABLE, NOT THE FIXED ONE) You will also need a CESS 3 inch cable with 90 degree heads: https://www.amazon.com/gp/product/B082PLZB54/ref=ppx_yo_dt_b_asin_title_o04_s00?ie=UTF8&psc=1 Currently unavailable as of writing this, but you should be able to find a similar cable for this usage. Print Instructions: I recommend printing upside down with the port for charging the iPod pointed to the ceiling, this should keep the module slot clean. I personally use a Brim when I print this for ease of adhesion. I also recommend using full supports. I had the best results while using an Ultimaker on preferred slicing.