iSpindel holder and calibration base

myminifactory

This design is solving a small problem I had when servicing and charging my iSpindel devices. They were more than often laying on the bed or desk, moving aorund etc. I decided I could fix this, so this base was born. It fits the large Petling around 50mm diameter and holds it straight up. Also the base works as a small stand to calibrate the 90 degrees or zeroing the device. I tried to make it modular so that pieces snap together when having more than 1, it does work but i would need to work on thos snap fittings more, for the time being i would use just glue on those sides. Leave a comment and any feedback if you wish, it would be greatly appreciated. Cheers! Happy Printing and Brewing!