It Doesn't Have to Look Like a Raspberry Pi Zero Case #3

thingiverse

This Bright (Chinese) Red Filament is Awesome! It's a beautiful color Red, and perfect for this Raspberry (red) Pi Zero Case. The Pi slides in from the top. I'm gonna take a break from designing these cases for a while. I have only 1 Raspberry Pi Zero, and with 3 good designs (out of 9 attempts), I really don't need another case. I think this one came out Awesome! It's the best of the three, in my opinion. Black would look really cool as well, even Golden. I gotta finish my Pi 2 Motion, Temperature, Humidity sensors case now... My other Raspberry Pi Zero Cases:http://www.thingiverse.com/thing:1592588http://www.thingiverse.com/thing:1581003http://www.thingiverse.com/thing:1587402 Print Settings Printer Brand: RepRap Printer: JG Aurora A3 Prusa I3 Rafts: Yes Supports: No Resolution: .2mm Infill: 15% Notes: With this Bright (Chinese) Red, I used 3 vertical shells (1.2mm) and 1.2mm base and top. I wanted to make sure the sides (around 2mm thick) were as opaque as possible. Black is pretty much opaque at just one shell. Other colors, who knows... I highly recommend a Raft so the sharp corners don't curl up (that would be bad/sad). No support are needed and it only uses less than 10 meters of filament, but takes at least 3 hours to print (lots and lots of travel - at least with Cura 2.1.1 beta). Post-Printing Nasty Little Hairs You'll probably get nasty little hairs inside unless you have one of those really nice printers and slicers. So clean them out with a small file before inserting your P from the topi. It will be a snug fit, but will loosen with use.