It's a Cracker

thingiverse

It's a Christmas cracker, just like those ones that normally go on the Christmas table. Scored to make it easier to roll in craft card, it has a pleasingly low poly style, although you can forgo the line engravings if that's your wish. Designed to cut from A4 craft card. More details at: http://def-proc.co.uk/b/biehg Instructions Cut with a laser cutter; where cut types are identified by colour. In order you should cut: Green layer: fill engraving Black layer: line engraving (recommended, but optional) Blue layer: cut through (internal cuts) Red layer: cut through (final outline cutout) Construction: Place a cracker snap along the length and stich down at each end. Depending on the length, this might need trimming to length, but should lie flat. Roll the cracker and push the tabs through the respective slots. Tie one end with a ribbon. Fill with your cracker prizes (bad jokes, plastic tat and a paper hat are traditional). Tie the other end with a ribbon. Profit.