iTouch (4th Generation) Stand

thingiverse

A stable stand for an iTouch (4th Generation) supported in portrait mode. It works in landscape mode too, but not quite as well. No idea if it will fit earlier or later generations of the iTouch, since they vary slightly in width and depth. A nice feature is that it collapses flat for travel. Instructions Print with100% fill. The individual pieces will print most cleanly and with minimum stringing; the complete stand is included if you want to print it all at once, though you may need to do some cleanup on the verticals and the bottom of the base. The uprights simply push into the receivers on the base from the front. They are a tight fit at first, but quickly wear in. To hold the pieces together when collapsed, assemble them as in the picture, hook a rubber band over the notches in the uprights from in front, take it around the back and forward over the front, and hook it over the uprights again.