Jack O Lantern Candy Bowl or Lamp

pinshape

This design was entirely created to use the Vase Mode or Spiralize setting of your slicer. The Top and the Stem both should be printed with the smallest part on the bed. I also used a brim of 20 perimeters on both of those parts. On the Top part I made sure to uncheck the infill top and bottom settings so that it only printed the outside. On the stem I added supports to the bed to help it print correctly. You may need to superglue the top and stem parts together. I just filled in the "cuts" on the main part using a Sharpie, but you could paint them too.  You could also put an electric tea light into it to make it glow. I used a layer height of 0.2 mm and a wall thickness of 0.8 mm (double the nozzle diameter). I also slowed the printing speed down to 40 mm/s.