Jack-O-Lantern Candy Dispenser

thingiverse

The Jack-O-Lantern Candy Dispenser is a fun way to dispense candy over the Halloween period. The design features and internal structure that rotates to open / close a hatch in the mouth. It's easy to use... with the mouth hatch closed just pour candy into the hole in the top of the stem then rotate the stem to open the hatch and dispense candy out through the mouth. At standard scale the dispenser will take candy up to approx. 15mm in diameter. Scale up uniformly to dispense larger pieces. Scaling down is not recommended as it will reduce the internal clearances which may result in the moving surfaces to fuse so the dispenser will not rotate to open / close. This is an easy print but it is large and will take quite a while to print... but it's well worth the time / effort / cost. At standard scale the dispenser is approx. 110mm round and 88mm high including the stem. It will hold a surprisingly large amount of small pieces of candy... and can be used for years to come. Looks great in traditional pumpkin orange or any other color. Do not use any automated support. The required support has been designed in and should snap away easily (Refer to the images for additional details). More than usual clearance has been designed in so the internal part should rotate free straight off the build plate. However, if it has fused slightly it is most likely the base shaft area so use a craft knife to gently break it free to turn. Please refer to the print instructions and images for additional information... and post images of your Jack-O-Lantern Candy Dispenser in use for other members to see. Note: If you like this check out the rest of my fun and practical designs. Tips: Tips are not expected but are appreciated as they help offset my filament costs as much as anything else. However, as I live outside the USA tips cannot be sent to me via PayPal.Me as that service is not supported in my region and this is beyond Thingverse's control. If you feel like sending a tip please use regular PayPal and send it to muzz64nz@gmail.com and, to those who do, thanks in advance!