James Webb Hanging Mirror Art

thingiverse

# Summary Remixed from another thingiverse post https://www.thingiverse.com/thing:5194387, this is a design to be entirely 3D printed and not need any other manufacturing tools. # Printing To print this you'll need the following quantities of each of the sections: | Section | Quantity | | :----: | :----: | | A | 1 | | B | 6 | | C | 2 | | D | 4 | | E | 2 | | F | 4 | You'll use almost exactly 1KG of filament (1.022KG is the estimate). --- # Assembly To assemble after printing the only post processing of the piece you will need to do is remove the support material and clean the underside where the support was bonded to the piece. Then install the heat set inserts using a solder iron at around 500-600 F, being careful to only press in until it is flush with the back side. If you overheat the piece you might need to run a screw through the insert to clear out any excess material that heats up and melts into the screw path.