JB4 and Bluetooth Adapter mount

prusaprinters

<p>I just got my JB4 piggyback Group 7 for my B9 S5 Audi yesterday and wanted to figure out a better way to mount it to my car. &nbsp; &nbsp;I first came across the idea for a way to mount the JB4 and the bluetooth adapter for it which is what you see in the pictures. &nbsp; &nbsp;I then decided to add a couple of ears so that you could choose to use this part itself to help secure your JB4 in the engine bay.</p><p>I have a Group7 JB4, &nbsp; I'm not 100% positive if all the other groups are the exact same size or not (I assume most of them are), but the bluetooth adapter definitely is.</p><p>Print this with a heat resistant filament or resin. &nbsp;I also plan on putting a 500ºf black spray paint coating on this as well before i mount it in place. &nbsp; There is slack in the fitment on this so you can easily slide your jb4 in place, and still have room for a few layers of paint without it becoming a pain. &nbsp; I plan on using some double sided tape to hold the bluetooth dongle in its place as well. &nbsp; I printed this first one to test fitment, but i will be printing the version with the mounting ears on it to mount inside my car. &nbsp; Also, &nbsp; I made sure the bottom of it was nice and flat so you could easily print this on your build plate without any supports at all. &nbsp; I also limited my fillets on that bottom edge for the same reason, &nbsp;to make printing without supports easier. &nbsp;All of the edges are 5mm thick, so you could hollow it out and infill if you wanted to go that route.</p><p>Please post a make if you decide to try this out.</p>