Jeep Wrangler Light Mount

thingiverse

I added hazard flashing lights for my search and rescue jeep but needed a good mount. The mounts fit the slim flashers on amazon -Ultra Slim 12-LED Surface Mount Grille Flashing Strobe Lights https://smile.amazon.com/gp/product/B07F5DFTMY/ref=oh_aui_detailpage_o02_s00?ie=UTF8&psc=1 you'll also need, m3 and m4 bolts, and any random screw for the rear mount to the bumper plastic. There's also an alignment piece to hold up to the front wheel fenders so you know where to drill the holes (the label on the alignment piece that says 'inside part' is the end that would be inside the part if it was printed in it entirety). I printed at .2 and with Raptor from makergeek and the threads hold up quite well, M4 for the mount to the jeep and M3 for the bolts to fasten the lights. If you use a different material id probably suggest an extra shell probably 3. post processing i was out of black filament so i used my gray and sprayed them with a matte black spray paint. post install i applied some sealant around the light housing edge and the fitting, one common issue with any LED kit is water gets inside and can cause a short, always take the precaution if you can.