Jelly Comb keyboard holder

thingiverse

The folding Jelly Comb keyboard has no built-in tilting mechanism. For a remote-control ground station, I found that adding a slant to keyboard made for more comfortable keyboard input. The project has 3 printable pieces that are held that are aligned on a 1/16” x ¾” x 9” aluminum backbone. The keyboard holding plates are glued to their rear riser, while the center support is a single piece. It was designed this way to reduce the excessive use of supports. To complete the project print two keyboard holders, two end angles and a single mid-support piece. Add your own 1/16” x .75” x 9 “ backbone – no additional hardware needed.