Jetson Nano Case w/ 92mm fan (v3 June 7)

thingiverse

### Update v3: ### Test new locking mechenism. Added printed version in PETG filament. My printer is still skipping prints even at 60mm/s, so it looks kind of weird. Top is around 2 mm too low, also going to enlarge the screw hole for top fan to 5.5mm d, since it's way easier to use pc fan screw than m3 for top fan. I'm fixing it tmr. Also I think the fan is 92mm, not 90mm like what i wrote before. ## still LOOKING FOR A LOCKING MECHNISM. if you have any suggestion let me know. I don't know how to lock the two part properly, does it has to be a screwed in ? i wanted it to be some kind of soft lock, so it is easy to open up and close to add wire and stuff ### Update v2: ### Finally fixed printer, just printed v1 and there are some minor adjustment for the front io panel, and also buffed up the back connector place. Top not changed so much. ### Original: ### This is a detailed model for Jetson Nano that fit 90mm fan, and have holes for everything. I'm fixing my printer right now, my printer bowden extruder is fking broke. I'm going to print out the design and update this design in the next few days with real photo. All screws are M3, besides top fan uses standard pc fan screw. M3 screw does not fit in jetson nano screw hole, I just used a drill to make it 0.01mm larger to fit the M3 screw. Don't break your board. Also all screw holes are quite bigger than what the specification of screws are, for example M3 holes are all set to 3.5mm diameter, simply because my printer sucks and the holes are also created too small, or the ABS material shrink and cause the hole not straight. Let me know if you have any good suggestion, I will consider all options. ps. Also working on a 120mm fan case, since this 90mm case is already 110mm in width, why not just make it a little bigger am i right?