JG AURORA Z-603S - SIDE WINDOWS - SET 2 (280 x 180 mm)

thingiverse

SET 2 adapted to be printed with your S-603Z ... If you print ABS, glue parts with acetone. Sand if needed. If for some reason there's 'holes' in your prints, treat them with ABS slurry (50% acetone & 50% ABS) and sand. FINAL THOUGHTS about closing your printer: You may add windows to your printer for aesthetic or for practical reasons (dust protection, noise reduction or stabilising chamber temperature like in my case ...). Have in mind that you are adding a MOD to your printer which has not been tested by the manufacturer and which is likely to affect the future behaviour of your machine. So … you do this at your own risk! Under normal circumstances the X, Y and E0 steppers run hot. I presume they will get even hotter after closing both sides of the printer. This is clearly a CON, so keep an eye on this. Monitor temperatures and compare them with the values provided by the technical specifications/data sheet of the used steppers mod. Fans should be fitted to these steppers (and heatsinks … the X-Stepper will be a nut to crack). - - - UPDATE 2021.09.04: I've been monitoring temperatures and the X-stepper runs really hot, reaching up to 70-75ºC. Adding a fan will bring it down to safer 50-55ºC (no heatsink used so far). Mounting this fan support is still a bit fiddly, but I will mature the design to make the installation more convenient Find it here: https://www.thingiverse.com/thing:4949038 - - - Always have in mind what materials you will print with after. In addition, I would recommend not to print the frames in PLA. Better use ABS or PETG as they can withstand higher temperatures inside the chamber without deformation. Enjoy! O. JG AURORA Z603-S JG AURORA Z603S JGAURORA Z603-S JGAURORA Z603S