JGAURORA A3S or A5 Alternative Filament Sensor Holder

thingiverse

This filament sensor holder enables side installation, allowing for a different type of micro/momentary switch, such as salvaged from a Canon Pixma MX492 or other inkjet printers. ## Divergences from Dirus_virus version The addition of a hole for an alternate 3.75mm micro switch from the side where it touches (the first hole is 1.63559 away) has been made, with the same 2.8mm diameter as the original. Moving the switch on the X axis by 0.225 to center it on the filament hole has also been done. The switch hole was moved on the Z axis by -2mm for more precise placement. A groove below the switch is left open for wiring, which comes from that end on the alternative micro switch. A removable side chunk allows installing while keeping filament installed. ## Customization STL files are included and ready to print. If needed, change or use the blend file (always select "Selection Only" in the export dialog): Select "FilamentSensorHolder ..." then export. Select "removable chunk", export, then rotate it by -90 on Y in the slicer or other program to print without supports. ## License - The Creative Commons - Attribution - Share Alike license applies (http://creativecommons.org/licenses/by-sa/3.0). (CC BY-SA 3.0) - Created by Poikilos and Dirus_virus - Based on JGAURORA-A5-Filamentsensorholder-BondtechBMG-byDirfeldt by Dirus_virus (https://www.thingiverse.com/thing:2780658)