JGaurora A5 frame brace remix

thingiverse

I used the cr-10 frame brace as a way to make a brace for the JGaurora A5 printer. I extended the lower brace to allow the bed mount to clear the brace rods. I used sheet metal screws to attach to the base and the z tower. The rods are 5/16 or 8mm threaded rods cut to length and you will need 8 nuts to suite the rods or you could also use wingnuts on the top brace. On the A5 I had to move the bottom piece towards the front of the case to clear the usb ports so the piece was offset to suite the offset of the case. To open the case you will have to remove the lower mounts. This mod has really improved my prints and allowed faster print speeds. You could probably mount from the backside of the frame but you would have to design a new filament spool mount.