JGAURORA A5 PICAM_MOUNT

thingiverse

20180214 - Print the bolts at 90%+ infill or they can break. Alternately, you can use a metal M8 bolt and nuts/washers. 20180215 - Added a thicker version of the picamMount. V2 is thicker and should be stiffer and vibrate less with movement. I want my picam to move with the bed so I needed a place to clamp the picam mount into. So I designed a set that swivels. Note you still need M2 bolt and nut for the camera as I can't design an M3 bolt and nut that works in plastic. There is a installation guide STL - DONOT PRINT THIS. It's just to show you how to install the parts. The basic parts that you need can be printed from the BASESET (no brim no raft) and BOLS_N_WASHERS (brim). I printed this in 0.1mm. The infill I used was 50% mainly for the bolts to be stronger, if you use wall of 1.2mm, the infill for the other parts may be lower.