Jitterbug Fishing Lure (Jointed Version)

cults3d

This is a 3D printed replicas of a jointed Jitterbug fishing lure This is also available in the Jitterbug Bundle which includes all 4 different sizes. The lures are printed in two halves and then glued together. NOTICE - Keep in mind the printed lips on these can be fragile compared to the metal lip versions you may be use to. Once sealed with epoxy they held up well... just don't expect to fire them off rocks or anything. These also do not have the hook hangers regular jitterbugs have so the hook can tangle with each other. Hardware Required to Assemble Lures Alignment Pins (made from 1.75mm filament) (5) #6 Figure 8 Hook Hangers (Available from https://lurecomponents.worthco.com) I used #6 Treble Hooks w/#3 Split Rings Tools Required to Assemble Razor Blade/Knife Drill and Bits (1.8mm or a 5/32") Lighter CA Glue (superglue) CA Accelerator Sand Paper Paint Epoxy (to seal everything up) More info on all of these individual lures can be found on my website. https://www.theneverendingprojectslist.com/fishingprojects/jointedjitterbug/ NOTICE - My files and designs are all Copyrighted © and are exclusively for private and personal use. Even if you purchased these files that Copyright means you are NOT allowed to sell the model or any derivative of the model for economic or financial gain. For example, you cannot sell the digital model, a derivative or adaptation of that model, nor can you sell prints of the model. I do however grant permission for persons who purchase any soft bait molds to sell the rubber soft baits you make with one of my printed soft bait molds.... but again you CAN NOT sell the actual models of the baits.