Jr module Adapter for Frsky Taranis lite

thingiverse

This is adapter is designet to fit an Frsky Taranis lite and with it you can install jr modules. For this build you will need some m2 hardware thin cables that have a female and a male connector and some ~1mm thick doublesided foam tape. After printig make sure that the base slides well and also clicks into place. Put it together like in the picture above. If you use the cables with the square profile connector then you must detach the black connector plastic and instead of it you can use some heatshrink to isolate the cables.(otherwise they will be too thicc) The higher end of the adapter strap gets some foamtape so that the cables that get sandwiched between the groovs in the base and the strap doesnt wiggle themself loose. The female end of the cable gets connected to the base via the strap. The male end will just be connected directly to the module. IMPORTANT: All things i designed use NO supportmaterial thats why you will need to print the base on the face where there are the slots for the transmitter and for the holder print it standing up the same goes for the brace.