K'Nex adapters for Arduino and electronic hardware

thingiverse

---- This project is in developpement --- Please see the Github project's page: https://github.com/MxBoud/ardublocklyForKNexRobot ---Description of parts--- --MotorToKNex.stl-- This part is a bracket to mount the Kuman stepper motor (http://kumantech.com/kuman-stepper-motor-for-arduino-5-sets-28byj-48-uln2003-5v-stepper-motor-uln2003-driver-board-dupont-40pin-male-to-female-jumper-ribbon-cable-k67_p0057.html). Fixation is done with a M3 screw. --MotorDriverToKNex.stl-- This part is for mounting the Kuman stepper motor drive (http://kumantech.com/kuman-stepper-motor-for-arduino-5-sets-28byj-48-uln2003-5v-stepper-motor-uln2003-driver-board-dupont-40pin-male-to-female-jumper-ribbon-cable-k67_p0057.html) on a K'Nex base. Fixation is done with four M3 screws. --SonarToKNex.stl-- This is a K'Nex connector for a ultrasonic ranger (http://kumantech.com/kuman-5pcs-hc-sr04-ultrasonic-distance-measuring-sensor-module-kit-for-arduino-uno-mega-r3-mega2560-duemilanove-nano-raspberry-pi-brobot-k18_p0033.html). Fixation is done with a M3 screw. --ArduinoMegaUnoToKNex.stl-- This is a mount for an Arduino Uno or Mega board (holes can adapt to both types of boards). Fixation is done with some M3 screws. --MotorShaftToKNex-- By printing two pieces of this part, the stepper motor shaft can be extended to attach a K'Nex rod on it. This part needs some improvements because it seems not strong enough. Fixation is done with six M3 screws.