K7XX mic attachment v2

thingiverse

A newer version of the mic arm addon for my AKG K7XX with my Sony ECMCS3 mic from my previous model: https://www.thingiverse.com/thing:2481074 This one is heavier but the mic is removable with the cables so I can take them off anytime and use the headphone independently. _______________________________________________________________________ Like the V1, this will scratch the plastic on the K7XX where the attachment clips on. This version contains 2 version, the friction fit and the one with gears. Both requires: - 1x M2 12mm - 1x M3 12mm - Nuts are optional for the gear version, 1x M2 nuts for the friction version - Gear version requires extra M2 12mm and friction version require a M2 8mm I would recommend some lock tight for the side swivel joints and some cable sleeves Print it hotter for stronger parts. This should work with K702, K701 or similar style headphones. Wire can be route in the slots, I used blu tack and sewing thread to held it in place, loop the mic wire in the side swivel joint. The mic holder connector to the side swivel arm is 5.2mm diameter if you wish to make your own mic holder. ______________________________________________________________________ Update:16/05/2018 Added desk clamp attachment: The desk clamp and the screw can be printed with 20-25% infill The side sliding clamp screw should be print with 100% infill The rest of the parts I've printed with 45%. but it should be fine from 30% upwards ___________________________________________________________________ Update: 21/04/2019 Added attachment for Mpow 2 in 1 Bluetooth receiver/transmitter