K8200/3Drag Full Graphic Controller Enclosure

prusaprinters

<p>An <a href="http://www.k8200.eu/">K8200</a>/<a href="http://reprap.org/wiki/3drag">3Drag</a> enclosure for the <a href="http://reprap.org/wiki/RepRapDiscount_Full_Graphic_Smart_Controller">RepRap Full Graphic Smart Controller</a>.</p><p>It was my design goal to achieve a solution with as few components as possible and preferably without screws. In the design process, my goals were achieved, but the solution was difficult to print and did not have the strength I wanted.<br>I ended up with a design using only two screws, press fits and is easy to print ...</p><p>The hole on the left side is for adjusting display contrast and the X button is reset.</p><p>Besides the printed parts you will need two hex cap M3x12mm screws (<a href="https://mdmetric.com/fastindx/912socketscrew.pdf">DIN 4762</a>). Self threading plastic screws can be used instead of M3 screws.</p><p>Print the following and assemble as shown on the picture:</p><ul><li>1x Enclosure</li><li>2x Clips</li><li>1x Knob</li><li>Optionally 2x Insulator for M3 screws</li></ul><p>I used PTEG plastic for the enclosure shown on the picture, as it has very little warping. I think most filament types will work as long as it has some springiness.</p><p><i><strong>&gt;&gt; If you like it, please leave a like, rating or a tip... :)</strong></i></p><h3>Print Settings</h3><ul><li>0.20mm layer height, 25% infill</li><li>3 perimeters, 3 top and 3 bottom layers</li><li>No support or elephant foot compensation needed</li></ul>