kali's teeth

thingiverse

--If you choose to print this and get your dangley bits stuck in it its your fault not mine-- ~~I may edit the connector to take the notches out of it and maybe reinforce it, though I might not.~~ edited just needs reprinted to confirm correct hole spacing I'm not the largest tool in the shed but even when the tool is soft its a tight fit. I suggest removing the points on the teeth unless you want the more intense experience (they still do the job without the very tip) Should fit all CB-#000(s) devices. If you have any ideas for modifications feel free to suggest them. Print settings I used were (not my suggested settings) .2 layer 3 walls at.8 5 top/bottom at.6 0 infill (don't do this if you plan to use it) printed with brim used YuriZaprov's "CB6000 Base #2 Replacement" for the connection point July 5th update teeth_v2 is not tested will reprint to test fit when i get more filament.