Kannu 1.0

thingiverse

Started exploring Fusion 360, and this is what I created out of it. A simple watering can for my succulents. Remember to switch to vase mode in your slicer software. This model was sliced with Slic3rPE version 1.42.0. Here are the settings used: Material: PLA Layer height: 0.20mm, Normal quality Infill percentage: 0% Raft and brim options: No Solid layer counts: Top 0, Bottom 4 Perimeter settings: 3 or 4 should work well It took approximately two hours and thirty minutes to complete.