Karearea Talon Racing Pod

thingiverse

This is my pod for the Karearea Talon. It is designed around the following components and is a tight fit. Camera: Runcam Micro Swift http://bit.ly/2FWbfDP RX: XSR http://bit.ly/2FXHq5K VTX: Unify HV Race VTX Antenna: AXII ufl FC: Flip32 F4 http://bit.ly/2Du5IWB ESC: 4in1 30a 2-5s http://bit.ly/2G0EG7W The fins act as camera protection and house all antennas. There are 2 tubes for the rx antennas and then the AXII fits in the bulge at the back. To attach the pod to the frame you will need some M3 nuts and bolts. V3 adds more camera protection and a bit more room in the pod. It also adds a 45' 4 LED mount on the back (should be the perfect angle for people to see your LEDs when behind you). V4 goes back to the V2 shape, with added horns for camera protection. It also swaps out the normal hexagon M3 nuts for square ones (http://bit.ly/2rV463U). The hole for the AXII has been moved out a bit, this exposes it slightly but gives it a much tighter mount. A 45' LED mount for a 4 LED board has been added to the rear. Lastly the antenna holes are now triangular to allow them to print well without supports. WARNING: The Karearea Talon is not designed to be used without it's carbon fiber pod. By running this pod you increase the chances of damaging the aluminium parts of the frame in a crash. Use at your own risk. A lot of time and effort went in to designing this pod, so if you enjoy using it please consider clicking the Tip Designer button :)