Kawasaki Ninja 300 Fender Eliminator

thingiverse

Fender Eliminator for 2013+ Kawasaki Ninja 300 It uses all the stock lights/wiring so no need to mess anything up. Attaches using the stock bolts. Licence plate holes sized and spaced to suit QLD/Australian plates, should accommodate a wide range of sizes though. Instructions - Print the main bracket and feed & mount the lights in the side holes, might need some filing to get them just right. Add the stock licence light on the front with the spacer to close the gap. Should be able to get a screwdriver in through the rear hole to tighten the screw. Feed the wiring through the top hole and into the bike. Attach to the bike using stock bolts. Once installed, check the lights work and attach the back and bottom plate to seal it all up. Print Settings Printer Brand: Ultimaker Printer: Ultimaker 2 Extended Rafts: Yes Supports: Yes Resolution: 0.1mm or better Infill: 80-100% Notes: 0.1mm layer thickness or smaller 80-100% infill Brim around bottom ABS plastic for durability, PLA for quick and easy (mines lasted 9 months so far just fine) Give it a good coat of paint and clear coat to seal it up and give more protection Post-Printing Suggested after print work Give it a good coat of paint and clear coat to seal it up and give more protection