Kek Frog

thingiverse

Praise Kek the meme-lord. Shadilay my friends.https://sketchfab.com/models/fa5041e4b6f54b5ebc2f0d9dcc3d9073 Purchase your own: Shapeways https://www.shapeways.com/product/TC9KY6847/kek-frog?optionId=61498899&li=shop-inventory Sculpteo https://www.sculpteo.com/en/print/kek-frog-7/PA9o5KgT?basket=1&noclickredirect=1 Print Settings Printer: Minimax Rafts: Yes Supports: Yes Resolution: .1mm Infill: 20% Concentric Notes: -Print time 2:40:33 -White Inland PLA filament -Scale: x 60 y 63.52 z 21.72 -Extruder Temp: 202 C -Bed Temp: 60 C -Speed Infill: 50mm/s Inside perimeter: 40mm/s Outside perimeter: 40mm/s Travel: 125mm/s Retraction: 50mm/s Post-Printing Clean up Removed the raft. Carefully bent the raft around the feet to break it off. Started on the edges and slowly worked my way inward. Used a needle nose pliers to remove the supports. Used a knife to remove blobs, zits, and other unsightly blemishes. How I Designed This Creation Modeled in Blender. Started with circle toes. Used a cylinder and hollowed out the middle. Branched the long part of the toe off from some of the faces. Duplicated and rotated the 2 new toes and attached the middle together to make the foot. Duplicated to use for the back leg. Branched the rest of the leg off of the foot. Modeled the body from a cube. Designed the Kek logo and boolean it into the cube. Cleaned the mesh then. Boolean the completed the legs into the cube. Cleaned up the mesh. Deleted half of the cube and mirrored the geometry. Added a subdivision modifier and added new edge loops to form the geometry correctly. Tested the model with generic supports from my Minimax printer. Wouldn't print the front legs well. Thickened them to try and fix the problem. Improved but still not good enough. Imported the model into Meshmixer and generated custom supports for it.