Kingsman Knife Shoe

thingiverse

I AM NOT SURE WHY IT DOESN'T SHOW ALL THE THUMBNAIL PARTS AND ONLY SHOWS ON BUT IF YOU DOWNLOAD IT ALL FILES WILL BE THERE!!! This is a knife shoe as seen in the movie "kingsman, the secret service". This design requires two springs: a small one to push the mechanism out and fits in the smaller hole on the side of "sole", the bigger spring fits in the bigger hole in "sole" (can be made with a few smaller springs). Instructions: The design needs to take the place of a sole on an old pair of shoes, it can be assembled by pushing both springs in the then pushing "knife full" into the bigger hole in the "sole". then push "knife full" down and the hole should lineup so that "button" can be pushed in the big end first. After that push "pin" in after button to secure it all in place. How to use: push the "button" (the piece of plastic) sticking out the side of the shoe by clipping your heels together (as seen in kingsman) or pushing it and the knife will come out. To retract the knife push the same button in whilst pushing the blade in (as also seen in the movie). This designed worked insane when I printed it and the knife was very sharp, good luck and happy printing.