Klipper Hardware Conversion Mounts for MP Delta Pro/Atom 3

thingiverse

Hardware mounts for conversion to open source board/display. Running Klipper with Moonraker/Mainsail. The board/pi mount will need to be split if you plan to print on the MPDP, I just have a larger printer so I printed it in one piece. After removing the stock Lerdge X and it's heated bed controller, you'll also need to remove the stock fan and a few cable management clips. From there this mount will slide over the stock standoffs and adapt screw holes for SKR Pro 1.2, Raspberry Pi and a buck converter(lm2569). The front panel I used is an Fystec mini12864. To install this you'll need to remove the lerdge 3.5 tft, screw the drill guide in it's place and then drill pilot holes for the encoder and button. I found that a 17-18mm hole was large enough to show the LED's as well as still be hidden by the stock encoder knob. Then you can print the 12864 bezel and brace. The bezel will stop left/right/up/down movement of the panel. Then use the brace file to screw into the original 3.5 mounting holes. This is just to provide support so that the display wont move backwards when pushing buttons. It doesn't have to be extremely tight. When you see the brace start flexing it's got enough tension.