Kodama Trinus 3D enclosure 1.0 bracket

thingiverse

I don't know if it will be tweaked by Kodama in a later hardware revision of the Trinus 3D but currently the enclosure for the Trinus is not very well secured to the base plate of the printer. Print this four times (PLA or preferably ABS if you have a heated bed an expect a higher temperature inside the enclosure) and this should make your Trinus3D enclosure less wiggly. Update 2019-12-01: Kodama announced that they will release a new version of their enclosure sometime in the future. The revised enclosure hopefully fixes the mounting issue altogether and might be incompatible with this solution. Print Settings Printer: Kodama Trinus 3D Rafts: No Supports: Yes Resolution: 200µ Infill: 30% Notes: Reorient the part and place the bottom side on the print bed (this is the smaller side without the slot!). This way you get easy to remove supports and a nice finish of the rest. I have printed these parts with the original Trinus 3D sample filament and the "official" simplify 3D profile. They should fit nicely. Post-Printing Use your original clamping screws with this part.