Koss Porta Pro Headphone Holder for Oculus Quest

thingiverse

> ***Warning:*** A small number of people, some using counterweights, have reported cracked strap parts. None of them have used my clips, but since the clips put stress on that part I felt I should issue a warning. I have put my clips on and removed them a lot more than anyone else should need to and I have not had a problem, but I felt I should remind everyone that like everything else on Thingiverse, my models are: ***Use at your own risk.*** Spring loaded... OK, rubber-band loaded, but [they work great!](https://youtu.be/MPL0dstHSnw) **<-- Video!** ***Recommended*** *KossPortaPro_Quest_Clip_Jorg_Spring-Loaded Non-Adjustable v2.stl* This is a new version that gets rid of the extra screw joints but also cannot be adjusted. It will work for most people, but may not center the speakers perfectly on your ears. So many folks were having trouble with the screws I figured this was a good idea. *KossPortaPro_Quest_Clip_Jorg_Spring-Loaded v4.stl* - Same as v2 except narrower driver arms that allow more swivel. The v2 allowed almost no driver swivel. v4 has slightly longer threads on the screws. It works great with two [loom bands](http://www.amazon.com/dp/B00CS3TB48/?tag=designedbyjor-20) on each side! I also have a [*Rift S* version](https://www.thingiverse.com/thing:3616488) *Note that this really is a work-in-progress that will keep changing.* ***Warning:*** *The clips fit very tight. I would recommend snapping them on and leaving them. I am afraid they may damage the strap if snapped on and off enough times. They don't get in the way if you leave them while removing the rest. I put mine right at the end of the hard part of the strap.* I bought [Koss Porta Pro On Ear Headphones ](http://www.amazon.com/dp/B00001P4ZH/?tag=designedbyjor-20) because they don't have a mic to worry about. I would not have been able to do this so quickly if I had not been able to I start with [Jeremy from Tested's Rift-S headphone mount.](https://www.thingiverse.com/thing:3615447) Added the screws by themselves. Print them at 0.25mm layer hight and 10 shells and they will be stronger.