Kreg K4 Height Spacer to use with 2x4 Supports

thingiverse

Update 9/22/20 - I realized that the spacer blocks the bit and drill storage built into the bottom of the jig. The new version has a cutout to access the storage section. I left the old version in here in case you store your bits separately. The platform of the Kreg K4 pocket hole jib is 1 inch in height from the table surface, which makes balancing larger work pieces difficult. This spacer raises the platform up by 1/2 inch so that it is the same height as a standard 2x4 to help support the work piece. I have the Ender 3 v2 whose print bed is too small to fit the entire length of the spacer in one continuous print, so I had to split the piece into two using a half lap. The two parts self-align by using the screw hole pattern. The full length is 270mm so you can print the full piece if you have a CR-10 or similar with a bed size. The STL for this is also included. PARTS LIST - 4 x 1-1/8 #8 screws (https://www.homedepot.com/p/8-32-x-1-1-8-in-Combo-Truss-Head-Zinc-Plated-Machine-Screw-8-Pack-804891/204274706) - 4 x #8 nylon lock nuts (https://www.homedepot.com/p/Everbilt-8-32-Stainless-Steel-Nylon-Lock-Nut-4-Pack-800101/204274164) PRINT TIME About 11 hours, 131g of Filament for both parts