Kryptonite Fahgettaboudit U-Lock Mount Sturdy Remix

thingiverse

After my first print in PLA of the original Kryptonite mount broke I decided to redesign the mount to be more sturdy. Since the failure happened along the layer lines at the height of the lower bar of the "U " I flipped the print orientation by 90° to increase sturdiness in that direction. To prevent failure along the new layer lines the Sturdy Remix has been improved with two reinforcement groves for 5mm zip-ties that run perpendicular to the print orientation. There is also an additional canal in the bottom area to fix the mount the the downtube at a third position. The M5 screw behind the lock has to be a bit longer than most screws at M5x40mm. Also inlcuded is a remix of the rattling stop since I believe that my lack of them majorly contributed to the failure of the first print. This Remix is for those that can not or do not want to print anything but PLA but of course other materials are fine too.