Kuchipatchi Tamagotchi

thingiverse

Modelled after the Tamagotchi character Kuchipatchi. There are 4 versions available: solid and multi-part version, both with angled or flat feet. The solid version must be printed with support. The multi-part version does not need support and has a small compartment inside. A small steel ball or marble can be placed inside to give it more weight and make it stand up easier. A lanyard can be attached through the hole in the in the top part. The angled feet may look nicer when used with a lanyard, the flat feet enable Kuchipatchi to stand upright. Print Settings Printer Brand: RepRap Printer: Huxley Rafts: No Supports: No Resolution: 0.3 mm Infill: 20% Post-Printing Make sure to clean up the bottom layer of the multi-part version so the connector part fits inside. If the fit is too tight either sand down the parts a bit or scale them by 1 or 2% before printing.