KURA to * [flat panel bed walls]

thingiverse

Fits the KURA bed tent post clips to any flat panel bed wall. Small rims prevent the clips from slipping sideways. The STL works for 18mm wide walls, otherwise you need to change the *inner* parameter. Prints without support from two directions. Reduce the *rim* parameter a bit, if 1.5mm overhang is too much for your printer. There are a few more options if you don't mind printing with support, or in ABS - for example you can hide the clamp in the interior of the adapter by reducing the *teeth* parameter, which is currently set to full width for supportless printing. Looking for a KURA adapter to my flat panel beds (Parisot Cube), I found the Kura to Stuva adapter. I ended up redesigning from scratch, and adding the rims and clamp. Works fine printed in PLA, probably even better in ABS. There is a clamp angle parameter for springier materials.