kyria pimoroni trackball mount for acrylic case

thingiverse

I got the trackball breakout board by pimoroni but had already assembled my kyria with acrylic plates and oled screens on both halves, so I was looking for a decent mounting option. the original model seemed like a great idea for positioning the trackball, but it was designed in a way that would not accomodate the wide oled screens or the acrylic switch plate. I quickly cut it down in tinkercad (because I am a hack^^), reduced the height by a few mm to make room for the switchplate and cut off the rest of the cover in order to fit it with installed oled display etc. if you print this, you will have to cut out a bit of material near the edge of the oled display. will post a picture later. I was not able to position the printed piece otherwise as it would collide with the electronics. after installing the mount, I proceeded to insert some tiny m2 screws into the top hole of the trackball pcb and they screwed into the printed mount very easily. no glueing or anything like that required in my case.