Lab ATX Power Supply Front Panel.. Remix

thingiverse

Remix of the front panel for the Lab ATX Power Supply Skeleton Case by james_III I redesigned the front panel to install a CC/CV programmable power supply module from eBay, 2-20v at 2A, i didn't use the guts of the ATX supply, instead i installed an open frame supply i also found on eBay with a 12v and 5v output and used a small boost converter to bring up the 12v output to 23v for the max input of the power supply module, works great! I could have also used a 24v supply but the ones that were small enough and adjustable to bring it down to the max input of 23v for the module were a lot more expensive. I included a 5v USB jack i salvaged and put a fuse holder in the rear of the ATX housing that i gutted to hold my power supply, i kept the fan and IEC power inlet along with the input filtering on the back of the inlet to feed the new supply that i mounted inside. The reason was i didn't have a good working spare ATX supply and now i have more reliable output voltage, no load needed on the 5v rail which would just create extra heat, etc.