Lack enclosure with storage for the Ender 3 Pro

thingiverse

Lack enclosure with storage for the Ender 3 Pro. As a base I used three Ikea Lack tables, connected with the "invisible IKEA LACK connection - Printer enclosure" by MajoSc. https://www.thingiverse.com/thing:2736839 The filament guide thru the top is "IKEA LACK Filament Guide, screw version PTFE compatible" by Surfgeorge1. http://www.thingiverse.com/thing:3118326 All other parts I designed myself. Custom parts to print: One 230V holder for rocker switch (front) and 230V C13 chassis part (back) which is screwed on one of the lags and the bottom of the table. Several 230V Cable clips to guide the 230V cable. Two 230V cable entry to get the cable thru the printer floor. Eight Hinges (4 normal and 4 mirrored). Twentyfour Triangle corners to hold the side panels. Four Doorknobs. Four Doorstops. To buy: Filement holder (or choice one of the many available at Thingiverse). Mine came from 123-3d.nl. EU Power Kabel Euro IEC C13 AC right angle schuko. IEC Connector C14 plug, panel-mounted vertically. 10 A black. Glass Fuse 5x20mm 10A. 6 Pin Illuminated rocker switch red DPDT ON/OFF 15A /250VAC. Four M4 bolts to fasten the doorknobs. A lot of tyni screws to mount the hinges and triangles. Sidepanals for the printer cabinet: Polycarbonate transparent 3 mm - 48.5 cm x 22.2 cm: 2x for doors Polycarbonate transparent 3 mm - 48.5 cm x 44.4 cm: 2x for side panals Hard Polyethylene black 3 mm - 48.5 cm x 44.4 cm: 1x for rear panel Sidepanals for the storage cabinet: Hard Polyethylene black 3 mm - 31.4 cm x 22.2 cm: 2x for doors Hard Polyethylene black 3 mm - 31.4 cm x 44.4 cm: 3x for side panals Be sure to measure the exact sizes of the plastic plates needed as the final sizes can be different.