Lamp cord clip

thingiverse

Annoying ceiling cap hanging always too low made me to make this little clip. As we all know Ikea's things have plenty of place for improvement. Instructions Use 100% infill. The model was done for ∅5.2 mm cord. You can simply scale it in the slicer to adjust it for different diameters. For example: you have ∅6.5 mm cord, then you need to enlarge the model by 25% (6.5/5.2=1.25). The inner rounded surface is slightly angled for better cord holding. Use a clip as printed - glossy face downwards.