Lamp Shade

thingiverse

This was made as a replacement shade for a porcelain one broken years ago. reproduced to the best of my memory. The base is around 6", and couple probably be resized downwards quite easily, upwards may cause problems with the overhang on the flowery decoration. I printed it in ABS, Spiral Vase, with Zero top and bottom layers, and increased the extrusion width to 0.6mm - this worked well. It is delicate, but then so was the original! I used it with an LED bulb, and watched the temperate, which didn't go above 26C over several hours - please check, or be careful about replacement bulbs, especially if still old tungsten filament bulbs - I can accept no loss or damage if you burn your house down as a result of not checking it is safe in your installation! It just fits in a 200mm cube as designed.