Lanyard Safety Clip (Can also be used for Medals)

prusaprinters

<p>A Lanyard or Medal Safety Clip</p> <p>This will take a 1 inch or 25mm wide ribbon.</p> <p>Pulling on the lanyard will result in the clip pulling apart so it doesn't get stuck.</p> <p>Once printed test the pushing together and pulling apart of the two pieces, if still to tight use a piece of sandpaper to rub down the small nodule on the male connector until you get the desired pull apart strength.</p> <h3>Print instructions</h3><p>Once printed test the pushing together and pulling apart of the two pieces, if still to tight use a piece of sandpaper to rub down the small nodule on the male connector until you get the desired pull apart strength.</p>