Laser Cut CR2032 Holder

thingiverse

###Coin Cell (CR2032) Battery Box Vector files to laser-cut a CR2032 holder with a sliding wood lock. The red outline is the lid which can be cut from acrylic or wood. All cutting materials should be cut from 1/8" (3.2 mm) sheets of wood or acrylic. ### Instructions: Laser cut the pieces from the file. The black outlines are to be cut from wood, and the red from acrylic, though really any 1/8" sheet material works for either. Using glue (wood glue or epoxy works) join the pieces in the following order. The pieces are labelled in one of the images. 1) Glue the two side pieces to the shelf piece by inserting the tabs on the shelf into the slots on the side pieces. The tabs on the side pieces should be oriented upwards. 2) Attach the side pieces to the bottom, then attach the back piece to the assembly. 3) Attach the latch through the slot in the front piece, being careful with the glue so that the latch can slide from side to side. The small, longer peg passes from the inside of the box, through the slot, then into the smaller hole in the rectangular latch piece. Glue it in pace so that the peg holds the latch in the slot. Next glue the small shelf piece to the wider slot in the latch, so that it overhangs the box. 4) Glue the front panel to the rest of the wooden box pieces. 5) When assembled, you can place the acrylic lid over the top of the box, and slide the latch to lock or unlock it.