Lasercut hnefatafl board and pieces

thingiverse

Lasercut board and pieces for the Viking game hnefatafl. Pink is engraved (I set this to speed 300, power 20), blue is engraved (I set this to speed 300, power 35). They're separated out so you can engrave the pieces on both sides, at the end. Black is cut (etch), so I used speed 30, power 25 so it didn't cut all the way through. Red is cut through, I used speed 10, power 45. I did pink, then blue, then black, then red. As long as red is last, you're golden. At the end of the cycle, I held down the material and used a thumbtack to turn the game pieces with the star on, and the ones with the concentric circles on. I made sure they were flipped and then returned to their holes, and did a second pass with only the pink, so the pieces with markings on them are engraved on both sides and can easily be distinguished from the unmarked pieces.