Lead Screw Upgrade Mount for Pegasus Printer

thingiverse

This bracket can mount on both sides of the Pegasus 12" printer. There is just enough material to allow you to use two T-nuts to attach this to the frame. You'll need to lower your motor mounts as far as possible, as well as lowering your couplers as low as possible. You will also likely need to raise your bed slightly; either with 1/4" thick glass, or insulation. I'm using Aerogel insulation (wrapped in aluminum foil) and two sheets of 1/8" glass taped together. This allows the nozzle to reach the bed. This is a remix, but I cannot find the original files, will link to them when I can find them. All I did was take the standard nut-trap and cut out a corner so that it fits on the printer frame.