Led bed light / Lampe de chevet à leds

thingiverse

This is a simple led holder I built for reading in my bed. As it is located right under the roof, the light on the side is too far. Now there is a direct lightning to the book. Leds are a bit cold but it does the job! Print Settings Printer: Dagoma Discovery 200 Rafts: No Supports: Yes Resolution: 0.2 Infill: 15% Notes: Support is only needed for the led holders ie the long part (goulotte.stl). How I Designed This Other parts needed You will need a 12V power supply (don't know how much power is needed. Mine is 2.6A which is an old one I had, collecting dust on a shell. Works fine). One power socket compliant with your power supply. One slide switch Two 6xleds ribbons Two M2x6mm screws and corresponding nuts Two 75mm x 100mm x 2mm plexiglass / polycarbonat sheet A few double sided thin tape to stick this thing Custom Section Remark Thermal dissipation is around 40°C.