LED case for $1 WM flashlight
thingiverse
A case to locate a small and light led light on my two up printer. I sourced the parts from a $1 walmart flashlight. It is super bright! and can be attached with a ziptie to anywhere on a 3d printer. Some soldering required. Instructions Dismantle flashlight, battery cap screws off, SO DOES TOP, but it's on tight! Keep silver reflector, and led array. Remove spring, solder positive wire to where spring was soldered. Solder negative wire to a corner solder point. Insert reflector, in proper direction from back. Insert wires thru hole. Insert led array into reflector. Slide back cover in place. Power with 5v. Can tie directly into e end-stop power on printrboard. Zip tie on something and let there be light!
With this file you will be able to print LED case for $1 WM flashlight with your 3D printer. Click on the button and save the file on your computer to work, edit or customize your design. You can also find more 3D designs for printers on LED case for $1 WM flashlight.