Lego Helmet Collection Wall Bracket

thingiverse

A simple bracket to hold the Lego Helmet Collection. Tested with a 3.3kg load with the bracket fixed to the studwork. Available in larger and smaller variations. **Small Bracket - Tested up to 3.3kg load** Print time: 03:07 Filament Used: 23g 15% Octet Infill (Increased to 30% for angle supports) **Large Bracket - Tested up to 3.3kg load** Print time: 04:34 Filament Used: 38g 30% Octet Infill (Increased to 50% for angle supports) **Printer Settings** Nozzle Temp: 210 Deg C Bed Temp: 55 Deg C Initial Layer Speed 35mm/s Normal Layer Speed 50mm/s Initial Layer Line Width 140% I added in support blockers within cura and modified the settings to increase the infill of the angle supports up to 30%. Shown in images. **IMPORTANT **- This bracket is for use with screws that have a thread width of no more than 4.2mm. Do not use bigger or it will bite into the print and potentially crack the layers. Do not over tighten as this could also crack the layers.