Lego separation tool

thingiverse

Here is my take on the Lego separation tool. It's a remix. I wanted to create an angle to make it easier to remove parts that were adjacent to other parts. It was also important to me to design a part that doesn't need support. This prints well on my printer and doesn't need any clean up before use. Although it fit well for me, you may need to scrape the inside of the removal head as the overhang may not print perfectly on everyone's printer. Print Settings Printer: FLUX 3D Delta Rafts: No Supports: No Resolution: .03mm Infill: 20% Post-Printing May need some clean up at tool head depending on printer. It's a simple process of scraping inside a bit. How I Designed This I used www.tinkercad.com to create this remix.