Levitator

thingiverse

This a small remix from the great design of RxBConcept! All the credit for the original design goes to the Creator! Main things that where changed are: - Added a RGB-LED at the Bottom for extra effect (this LED changes through all colors) - Shrunk the Base in the vertical axies by removing the space needed for the Arduino pin header(female) - Changed the base to include our own switch and DC-Jack. The design dose not feature Bluetooth! The new Code is in the attachments, just open in the Arduino IDE and Flash. **millis() and micros() are disabled ** and only the levitator.ino was changed. The 3D-Files can be exported or viewed on [onshape.com](https://cad.onshape.com/documents/da0a1f88a76ad84064ac02c7/w/25f7841cec0d43629ea23ae7/e/140255ed707a1a0f0c646a06?renderMode=0&uiState=61e99bccf41a3b31efe31c7d). Things you need (Hardware): - 10mm RGB-LED with common Cathode (if you change the wiring of the schematic and the Code, you can also use the Anode version. - DC-Jack_Female like [these ones](https://www.amazon.com/dp/B01J1WZENK) - Switch that fits into the case.. can be anything else(you just have to modify the case), but we used a little over-killed switches. [Like these ones](https://www.amazon.com/dp/B07SPY9H7Y) - Everything else needed for the original You need to design your own PCB on a Proto-Board or manufacture it your self. but keep in mind, with the DC-Jacks we used, they stick way in the PCB, so design around that or change the Jacks! Other options, if you only want the led, are for example only print the "Levitator-Base-Top-V2.stl" and then air-wire the pins to the LED (dont forget the resistor!) and use my software. Tuning and everything else is done the same as Source *If you remove the cap at the bottom, that holds the coil in place, you will get a much more impressive Levitating performance! But the Coil is not screwed in place anymore, so it your decision!*