LG V20 dock

thingiverse

Heavily inspired by chenhj's iPhone dock (which in turn was based on Daelmanu's, I decided to create a similar dock for the LG V20. The dock is designed for use with a case (I'm using the Spigen Rugged Armor case), but with some small foam/felt padding you could use it without a case as well (which is probably a good idea if you're using it without a case, to prevent scratches). The cable routing system is the same as the iPhone dock: feed the USB-C end of the original USB cable through the large hole at the bottom, then move the entire cable to the other portion of the cutout and pull the cable from below. Depending on what kind of case you have, you may need to play around with how far you want to pull it down. Print Settings Printer: Monoprice Maker Select v2 Rafts: No Supports: Yes Resolution: 0.16 mm Infill: 15% Notes: I only used supports for the cable routing at the bottom. Note that the tolerances on the holes are very tight, so your printer must be dialed in fairly well to be able to successfully use it.